AMF (Auto Mains Failure)

AMF Control Panel is for controlling two DG Sets, Master DG and slave DG
This is a Module with Generator monitoring, protection and start facilities. Operation of the module is via three pushbuttons mounted on the front panel with STOP, MANUAL and AUTO positions. Selection of the ‘Auto’ mode is confirmed by LED indicator, and monitors the incoming mains supply (3 Phase or Single phase). Should the incoming AC mains supply fall below a configurable pre-set limit, the generator will be started, and load transferred to the gen-set.
 
When the AC mains supply returns to within limits, the module will transfer load back to the mains. The engine will be instructed to stop after a cool-down period. The module’s microprocessor provides comprehensive functions.

AMF control System provides:

  • Consistent Power Supply to the load.
  • Smooth Start/Stop Sequence
  • Audio/Visual indication of various fault conditions.
  • Auto/Manual modes of operations
  • Mains failure and voltage fluctuation detection.


Main features for AMF Panels (Auto Mains Failure Panel)

  • Range from 250KVA to 3000KVA
  • Logic Panels with normal source or with standby DG source
  • Basic protection under /over voltage, under/Over frequency.
  • Provision with future synchronizing.
  • Metering (Voltage, Ammeter, Frequency, KWH) & Battery charger unit
  • Modbus communication facility.
  • DG Breaker & mains Breaker (Optional)

« Back

loading